Announcement Announcement Module
Collapse
No announcement yet.
User Profile Page Title Module
Move Remove Collapse
Profile Sidebar Profile Sidebar Module
Collapse
Profile Picture
Minilab service
Senior Member
Last Activity: Today, 04:04 AM
Joined: 12-16-2008
Location: United Kingdom - Lithuania
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Minilab service
    replied to 3501 Problems with ARCNET
    Scanner should be powered, when you run ARCNET test. Otherwise you will not see it.

    If machine and scanner powered, but on ARCNET test you do not see laser pcb ( when to PCI/ARCNET board...
    See more | Go to post

    Leave a comment:


  • Minilab service
    replied to 3501 Problems with ARCNET
    Hello. Do what I said - from computer board disconnect ARCNET cables. There connect ARCNET cables from scanner. Run ARCNET software. This time you should see good connection with scanner ( should be OK...
    See more | Go to post

    Leave a comment:


  • Minilab service
    replied to EZ Controller Software
    Hello. Printing and scanning process is more comfortable on Ez controller than on Photopshop. On EZ controller you have typical Noritsu interface. Can work with 6 frames at the same time and have all...
    See more | Go to post

    Leave a comment:


  • Minilab service
    replied to 3501 Problems with ARCNET
    Hello. New version has QSS35. Have to use QSS35xx for laser model. ARCNET test software works stand alone. You do not need to install it.
    See more | Go to post

    Leave a comment:


  • Minilab service
    replied to 3501 Problems with ARCNET
    Run ARCNET test software. At least you should see connection between computer and laser control pcb. Only this board connected to computer directly. All other goes through ARCNET hub, which is on laser...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X