Announcement Announcement Module
Collapse
No announcement yet.
Noritsu 2901 lamp goes out and turns on and off Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Noritsu 2901 lamp goes out and turns on and off

    lamp goes out and turns on and off

  • #2
    It's mostly caused by a faulty lamp power supply.
    You don't say if it is the MLVA or Scannler Lamp, I'm assuming it's the MLVA lamp, in which case you can swap it with the scanner lamp power supply as they are the same.

    Also check all the fans in that area are operating and not clogged up with dust.

    Comment


    • #3
      I have had similar problems with my 2901 in the past- usually its the power supply. I have had them repaired in the past as I found an electronics guru who diagnosed and then repaired PCBs ( a dying breed).
      At least that way the failed component was new vs replacing the whole board with one that may be 80% through its life already.

      Comment


      • #4
        ES LA DE MLVA CAMBIE BOMBILLA Y SIGUE EL PROBLEMA

        Comment


        • #5
          change bulb and follow the problem, I will check the fans

          Comment

          Working...
          X