Announcement Announcement Module
Collapse
No announcement yet.
Noritsu 3501F, error 6209-003, Paper has jammed in Exposure advance unit Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Noritsu 3501F, error 6209-003, Paper has jammed in Exposure advance unit

    Noritsu 3501F, error 6209-003, Paper has jammed in Exposure advance unit, any help please?

  • Simply
    replied
    Problem identified, changed exposure advance unit and it is printing, zigzagging sensors value wonít change from 5 on defective unit

    Leave a comment:


  • Noritsu Help
    replied
    My guess would be either the exposure advance unit is not pushing the paper into the arm, or the rollers on the arm are not pulling the paper in.
    You can check the operation of the motors in output check, feed a piece of paper manually into each section and see if the rollers transport it properly.

    The instructions for adjusting the arm are attached.

    Leave a comment:


  • Simply
    replied
    All width and lengths please

    Leave a comment:


  • Noritsu Help
    replied
    Is the problem happening on all widths and lengths of paper, or is only on certain print sizes?
    Is every print jamming, or is it intermittently jamming?

    Leave a comment:


  • Simply
    replied
    Tried everything possible but problem is same, tried putting initial values there is slight difference in insertion length but wonít enter completely into turn unit

    Leave a comment:


  • Noritsu Help
    replied
    It seems like the original problem was just the dirty rollers, but most likely now the values are all wrong.
    Can you put the correction values back to their original settings by loading in the backup data?

    Leave a comment:


  • Simply
    replied
    After cleaning the rollers in exposure advance unit now paper is entering turn unit, it was not entering turn unit before, please look at the attached pic, problem still remains, any advise please?
    Inside view When unit is pulled out

    Leave a comment:


  • Simply
    replied
    There is significant difference in value of other sensors, only exposure end sensorís value is 19 others are in range of 9-10, could it cause jam?

    Leave a comment:


  • Simply
    replied
    Exposure end sensor value is 19 in sensor adjustment is it ok please?

    Leave a comment:


  • Simply
    replied
    Thanks for reply, reverse unit appears to be in order and it is holding and rolling paper manually, I noticed that the receiving position of turn unit is not 2 mm from exit advance unit, I tried changing values but it remained lower by approximately 2 mm, seems like pressure release arm not in position, please any help on how to adjust the turn unit for accurate receiving

    Leave a comment:


  • Noritsu Help
    replied
    Check the reverse guide is not broken. It's the red part in the drawing.
    Make sure the rollers on the reverse guide are clean and gripping the paper properly.
    Last edited by Noritsu Help; 08-04-2019, 06:17 AM.

    Leave a comment:


  • Simply
    replied
    Thanks for your reply, tried all above all motors are functioning and sensors are ok, paper is not entering the turn motor completely missing by like half inch to be fed to advance motor 3 even after putting maximum value of -1.5 mm

    Leave a comment:


  • Minilab service
    replied
    Hello. 6209-​0003 means even when a specified length of paper is advanced after the exposure end sensor has turned DARK, the exposure end sensor does not turn LIGHT. Check that the exposure start sensor and exposure end sensor are not soiled, perform Paper Sensor LED Light Intensity Adjustment in Functions of Paper Sensor Adjustment. Go to output check and test motors. Also go to input check and test sensors there.
    Last edited by Minilab service; 08-01-2019, 10:52 AM.

    Leave a comment:

Working...
X