Announcement Announcement Module
Collapse
No announcement yet.
Noritsu 3411 error Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Noritsu 3411 error

    Can anyone please help? Ty Joe
    Can anyone please help me?
Thanks
Joe

  • #2
    The most common cause of this error is a failed 24V power supply (PS1)

    Comment


    • #3
      Were can i buy one?

      Comment


      • #4
        Not sure, as it has been discontinued by TDK- Lambda.The power supply type is ZWS240PAF-24/J. The Noritsu part number is I038361-00
        The other alternative is to get your power supply repaired.

        Comment


        • #5
          Ty so much. By any chance do you know anyone who can repair the power supply?

          Comment


          • #6
            http://www.photolabhelp.com/member/5...inilab-service

            Comment


            • #7
              Ty so much for all your help. Will let you know the outcome Joe

              Comment


              • #8
                Great. You're welcome.

                Comment


                • #9
                  1) I think it is the Pressure change motor ITSELF faulty.
                  2) I038361-00 a 24V switching power supply HAS NOT BEEN DISCONTINUED by Noritsu Japan yet. You can still order it . . . I just received some .

                  David Lam, Hong Kong davidlam@sinopromise.com

                  Comment


                  • #10
                    hi,
                    sorry for the late response. got the power supply(e-bay) machine working 100% tyvm.

                    i do have a problem with the 35mm carrier that is attached. we do not use it anymore. is there a way to disconnect it? it gives me an error "remove the 135 film from the film carrier".
                    i cleaned the mask, there is nothing stuck in there. any idea
                    ty
                    joe

                    Comment


                    • #11
                      Great glad the power supply sorted the problem.
                      The only way to disconnect the scanner on these is to load 3411 PRO software.

                      Comment


                      • #12
                        To install PRO software ( QSS-34PRO ) should be workstation CS-1 ( the same as on QSS32xx ) . On QSS3411 instead it connected SI-2400 scanner ( the same as on QSS-3102-2 ) . If with maximal sensor values have error then need to repair carrier.

                        Comment


                        • #13
                          Thanks Minilab Service, you are correct. I was thinking about the 32 series and had forgotten the 3411 uses a different workstation between the PRO and Digital(with Scanner) versions..

                          Comment

                          Working...
                          X