Announcement Announcement Module
Collapse
No announcement yet.
Noritsu D701 Service Mode Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Noritsu D701 Service Mode

    Is there a service mode for this model of Noritsu? I'm trying to set up a D701 that hasn't been hooked up for 2 years. The second, fourth, and fifth columns of the nozzle check have big chunks missing. I've ran the print head cleaning many times and there has been minimal change. I haven't had much experience with the D701. Any ideas on what to try next?

    Thanks!

  • #2
    On D701 system software ( box, where see ink colons ) press ''Maintenance'' . Then on keyboard press F1 and F9. On pop up box type 2260 and press ''Enter''. Now you are in service mode.
    In service mode you can run head power cleaning or power cleaning 2. They will take a lot of ink, but might to clean. Can use cleaning ink cartridges ( instead regular ) .
    If you need have all software to run D701. EZ controller can install without dongle on any Windows. Yesterday installed four D703 ( almost the same printer ) .

    Comment

    Working...
    X