Announcement Announcement Module
Collapse
No announcement yet.
Paper keeps jamming in Paper Advance Section Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Paper keeps jamming in Paper Advance Section

    Hi we have a Noritsu 3011 that keeps jamming in the paper advance section. The prints keep coming out right to the edge where the two metal arms grab the paper but they won't grab the print. I replaced the whole paper advance unit, and the same thing keeps happening. I also ran the output checks and all of the motors checked out fine. On the input checks the alarm comes on when I click "Interlock Switch (Paper Advance Section)"

    Any ideas on what to try next?

    Thanks!

  • #2
    Update:

    I ran some prints through with a magnet on the paper advance section door. The two metal clamps that grab the paper are just a couple millimeters too high and the paper hits the bottom metal piece directly instead of sliding over it.

    Comment


    • #3
      Do an adjustment on the mechanism to Allign it

      Comment

      Working...
      X