Announcement Announcement Module
Collapse
No announcement yet.
Agfa Dlab 1 " MZ controller communication error" Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Agfa Dlab 1 " MZ controller communication error"

    Hello to all I am new at this forum but I see nice work.

    I am trying to find this problem since 3 weeks now with no success
    Unit starts up normally with no error but when you try to print there is an error "MZ controller communication error" and it stop printing.
    At first it was printing 10 photos without error and then stops with this error.
    Making reboot it was printing again.
    Until now that it is not printing at all.
    Attached is the monitor showing the errors
    First it appears the PEata communication error with MZ Controller(MZ)
    After 1 second appears
    General error upon exposure. Exposure stopped
    I have already checked and or change the below
    1)Check all power supplies unit.
    2)Replace MZ controller.
    3)Replace 90A-CPU controller.
    4)Replace EC board.
    Until now there is no success.
    Last edited by gmaragosgr; 10-13-2013, 03:26 PM. Reason: adding photos
Working...
X